As low as
4 Stars Mostly good
Nick Kyriazi from PA wrote (February 09, 2015):
I bought the drawer pulls because the distance between the mounting positions was 5.25" and because the design and finish were similar to the original pulls. To my surprise, the new pulls did not attach like the original ones, with bolts passing through the drawer front. Instead, each pull handle has two circular bases that are to be attached with two screws to the drawer front. The pull handle is to be secured to each of the circular bases, but they must be attached to the bases before the bases are attached to the drawer front. Perhaps this configuration is advantageous if the separation distance between the handle sockets is not exactly the original distance, but I bought them because they had the same spacing. As a result, attaching them was not easy as I had anticipated, for logistical reasons. In addition, one screw that attached a circular base to the drawer broke off in the drilled hole. Apparently, the hole ID was not big enough. Perhaps anticipating this, an extra screw is included in each.