Skip to Main Content Skip to Footer Content

Continuous Sawtooth Shelf System

The average rating for this product is 4 out of 5 stars
Wood Type
Size
Store ID: 211565

Continuous Sawtooth Shelf System


This is an oversized item. An additional $20.00 per piece will be calculated in shipping charges at checkout.

Our Continuous Sawtooth Shelf System is the rebirth of a design that was used on many pieces of vintage furniture and cabinetry. These sawtooth supports were the primary way to make an adjustable shelf before the introduction of the hole and pin standard. This system now makes it possible to recreate the detail and craftsmanship of the past! Each set includes four supports, two pieces of cleat material, illustrations and instructions.

The continuous version of the sawtooth support is where the sawtooth cut runs the entire length on the support. This style allows several lengths to be joined for use in taller cabinets. It also can be used as a center section by adding a plain support piece on either end extending the length at a lower cost. The cleat material included with each set is the same dimensions as the supports so can be used for the extensions.

  • Wood Types: White Oak, Red Oak, Cherry, Poplar, Sapele
  • Sizes: 3', 4', 5', 6', 7'

Sawtooth Shelf System InstallationSawtooth Shelf System Installation

Specifications
Thickness 7/16"
Shipping Usually Ships In 2-5 Business Days
Finish Unfinished
Material Solid Wood
Unit of Measure Per Set
Width 1"
Product Review Summary
Based on 1 review
The average rating for this product is 4 out of 5 stars
Overall Rating: 4.0/5.0
Customer Reviews
June 03, 2013
Nicely made
This shopper rated the product 4 out of 5 stars

Nicely made, easy to install. One bit of advice: the shelf notching template assumes your shelves extend from back edge of rear standard to front edge of front standard. If your shelves are set back a bit from the front edge, you'll need to cut a smaller notch.

Dave from MO
You May Also Like