Restorers 2 1/4 Inch Solid Brass Trunk Corner

4/5 stars- used on cherry and cedar hope chest i made for my daughter. Had to use a coned grinding tool attached to air-compressor on interior corners to remove bumps etc.. Also heated corners with a torch to bend in area where last two holes are located,they are not forged perfectly square and due flare away (up to 1/8") from workpiece . Not to say you cant use them the way they are if you can except those tolerances on your project. made in india!

i bought them to go on the corners of my homemade wood boat seat over the gas tank. FOR SALT WATER, THEN LOOK PERFECT!

The Brass Corners were gorgeous, but they are very thick. I think they would be fine for building into a new chest, but as a replacements for thin brass corners that had deteriorated, they did not fit at all.

Excellent product and service

I purchased two corners using them on my white homemade door headboard. Really looks great over the trim.